H
EARTfelt Welcome dear friends of protection and control engineering, In the current VideoBLOG series, Siemens introduces us to its DIGSI 5 operating and parameterization software tool. The following chapters are available in this article:
Chapter 1: Introduction
Chapter 2: Creating a project and adding a SIPROTEC 5 device
Chapter 3: Device information
Chapter 4: Communication and hardware modification
Chapter 5: Routing information in the matrix
Chapter 6: Device Settings
Chapter 7: Display Editor
Chapter 8: Logic Editor
Chapter 9: Creation of a OHL (over headline feeder)
Chapter 10: Adding the transformer infeed configuration
Chapter 11: Adding of a transformer feeder
HEARTfelt Greetings and have fun watching!
Chapter 1: Introduction
Chapter 2: Creating a project and adding a SIPROTEC 5 device
Chapter 3: Device information
Chapter 4: Communication and hardware modification
Chapter 5: Routing of information in the matrix
Chapter 6: Device Settings
Chapter 7: Display Editor
Chapter 8: Logic Editor
Chapter 9: Creation of a OHL (Over headline feeder)
Chapter 10: Adding the transformer infeed configuration
Chapter 11: Adding of a transformer feeder
